As can be seen on the preceeding page there are three new bolts used in the cylinder and cylinder head design.

      When replacing head or base gaskets these bolts should be replaced with the new ones shown.

      If the cylinder studs are replaced it is still necessary to use 'O' Rings on the studs as was required with the early models. The new studs have a tapered thread at one end as shown below. Only the rear studs are changed.

CYLINDER STUD BOLT

PART NO.	DESCRIPTION	QTY.
341-11361-10	Cylinder Stud	4

TORQUE SETTING       1.8-2.3 kg/m(11-14 ft. lbs.)