14)	Remove balancer shaft No. 1 using the 8mm slide hammer.
15)	Remove weight No. 1. Wire shims to weight: they must be installed in same location. CAUTION: Shims on either side of weight have different thicknesses.
16)	Remove weight No. 2 and wire shims in place. Shims will be used in identical position on the new weight.
17)	Remove circlip located under L.H. bearing of balancer shaft No. 2.
18)	Remove L.H. bearing. Knock out from left side toward right side. Do not remove the bearing on the R.H. side.