19)	Install new circlip (Kit Ref. No. 13). CAUTION: Fully seat circlip.
20)	Install 30mm notched spacer (Kit Ref. No. 14) in through the R.H. bearing. Push in until it seats at bottom of hole in crankcase.
21)	Install 14mm long collar (Kit Ref. No. 5) in place of removed L.H. bearing. Tap into place (until collar lightly bottoms on circlip) using old shaft as a guide. (Note: Collar is interference fit into bearing cavity.) Old shaft (No. 2) may now be discarded.
22)	Install 20mm long collar (Kit Ref. No. 15) in R.H. bearing, Ref. No. 6-17.
23)	Grease seal (Kit Ref. No. 6) and install with closed end facing out.