24)	Install 1mm thick shim (Kit Ref. No. 7) on top of seal.
25)	Install spacer (Kit Ref. No. 8) (17mm long half circle) on top of shim. Position to allow installation of new crankcase bolt.
26)	Grease and install 4mm thick spacer (Kit Ref. No. 4) and two new bearings (Kit Ref. No. 3) into new weight No. 2. Spacer goes between bearings.
27) 28)	Check to be sure crank has not moved. Pistons must be at T.D.C. Engage new weight No. 2 (kit Ref. No. 1) with balancer chain and set into place with shims properly installed on each side.
29)	Turn weight until marked tooth aligns with mark on crankcase. NOTE: Remove slack from top of chain when timing weight No. 2.