34)	Complete assembly of shaft No. 1 (front weight) by dropping in plug, Ref. No. 9-10, and pushing in rubber-covered plug, Ref. No. 9-11.
35)	Turn shaft No. 2 counter-clockwise just enough to allow installation of crankcase bolt. Use new bolt (Kit Ref. No. 18) and copper washer (Kit Ref. No. 17).       CRANKCASE BOLT TORQUE: 15 ft-lbs.
36)	Install large nut on balancer shaft. Tighten slightly.
37)	Apply RTV sealant or Yamabond No. 4 or No. 5 to small rubber plug (Kit Ref. No. 16) and install in 4mm oil hole near crankcase vertical bolt.
38)	Clamp dial gauge on crankcase. Position indicator as shown. Check chain freeplay at T.D.C. (Move weight No. 2 to check chain play.)