TX750                         MISCELLANEOUS SERVICE INSTRUCTIONS (cont.)

SELECTION OF CRANKSHAFT AND CONNECTION ROD INSERTS (cont.)
The correct insert can be determined by one of the following formulas.
Crankshaft Inserts
	Crankshaft Housing No. minus (-) Crankshaft Journal No. = Crankshaft Insert No.
		Example:	If crankcase Housing No. is 6 and Crankshaft Journal No. is 2, then, 6 - 2 = 4; No. 4 insert should be used.
Connecting Rod Inserts
	Connecting Rod No. minus (-) Crankpin Journal No. = Connecting Rod Insert No.
		Example:	If Connecting Rod No. is 5 and Crankpin Journal No. is 2, then, 5 - 2 = 3; No. 3 insert should be used.
OIL CLEARANCE
Oil clearance after installation may be determined by the "Plastigage" method. Correct oil clearance will be:
			Crankshaft bearings - .036 ~.059mm (.0014"~.0023") Connecting Rod bearings - .034~.057mm (.0013"~.0022")